CoBex Recorders, Inc.

UL Registered Firm (Certificate Reg. No. 10000642)

 
ISO 9001:2015
EN ISO 9001:2015
BS EN ISO 9001:2015
ANSI/ASQ Q9001:2015
Certificate Reg. No. 10000642


CX9000 Ink Recorders
CX9000 Thermal Recorders
OEM Recorders
Single Pen Recorders
Two Pen Recorders
Temperature & Humidity Recorders
Recorder Part Numbers
Chart Selection
Recorder Input Options
Recorder Accessories
CoBex Order Form
CoBex Recorder Manual
Contact CoBex

Recorder Input Options

CoBex Recorders, Inc.

The recorders manufactured by CoBex are capable of accepting the following types of inputs:

 

Temerature Recorders

 

RTD TEMPERATURE PROBE

The temperature probe used with the recorder utilizes a thin film platinum RTD (Resistance Temperature Detector) sensor housed in a stainless steel body. The RTD has a resistance of 100 OHMS (at 0ºC) and an alpha of 385 (or 0.00385 OHMS/OHM/ºC).

The stainless steel body of the probe has a diameter of 1/4 inch and is available in a 3 inch and a 6 inch probe body length. Minimum length of the probe's wire is 8 feet. Custom wire lengths for probes are also available.

Accuracy of the RTD sensor is +/- 0.12 OHMS @ 0ºC

RTD Resistance Tables: (RTD TABLE ºC)

 

Humidity Recorders

 

HUMIDITY SENSOR

A monolithic IC humidity sensor is used with the recorder to sense and record RH (Relative Humidity). The humidity sensor has a wide operating range of -40 to +85ºC (0-100% RH) and is usually paired with a RTD (Resistance Temperature Detector) sensor in order to sense and record both Temperature and Humidity.

These sensing elements are housed in a single ABS probe body. The probe body has a diameter of 1/2 inch and a length of 2.56 inches. Minimum length of the probe's wire is 8 feet. Custom wire lengths for probes are also available.

Accuracy of the humidity sensor is +/- 3% (0-100% RH).

 

 

Voltage Recorders

 

VOLTAGE INPUT

The recorder is capable of accepting input from a voltage source (such as a transducer). Standard input voltage values are as follows: 0 to 1 volt, 0 to 5 volts, 1 to 5 volts and 0 to 10 volts. The recorder can be programmed to have the lowest input value correspond to the center of the chart OR to the outer edge of the chart. The pen arm of the recorder tracks linearly between the minimum and maximum input voltage.

Accuracy is +/- 0.25% of Span.

 

 

Multi-meter, Current Recorders, Voltometers

 

CURRENT INPUT

The recorder is capable of accepting input from a 4 to 20mA current source (such as a transducer). The recorder can be programmed to have the lowest input value (4mA) correspond to the center of the chart OR to the outer edge of the chart. The pen arm of the recorder tracks linearly between the minimum (4mA) and maximum (20mA) input current.

Accuracy is +/- 0.25% of Span.

 

Home | OEM | Single Pen | Two Pen | Temp & Humidity | Part No. | Charts | Accessories | Order

CoBex Recorders, Inc.
6601 Lyons Road, Suite F-7
Coconut Creek, FL 33073
 Tel: (954) 425-0003
Fax: (954) 425-0509

To place an order, please order online
by clickng on the "Order Form" button located
on the left side of this page.

For questions or quotes, please email
CustomerService@CobexRecorders.com