OPTIONAL FEATURES

CHANGE CHART ROTATION SPEED

Note: Use this procedure only when the available ranges (that are programmed into the recorder) do not include the chart rotation speed that is needed. That is, 24 Hour and 7 Day chart rotation speeds may already be programmed into the recorder as a different range. Refer to the section CHART "RANGE" SELECTION if this is the case.

To change the chart rotation speed of the recorder, first unplug the unit from the main power supply and disconnect the battery (if the recorder has the optional battery back up feature). Next, press and hold the "change chart" button (#3) and re-connect the recorder to the main power supply. Once power to the recorder has been established, release the "change chart" button (#3). Note: the pen(s) will not be moving if this step is successfully completed.

Three Button Touch Pad

The LED will begin flashing in sequence to show the current chart rotation speed that is configured for the recorder:

Flash 1 time - 24 HOUR
Flash 2 times - 7 DAY

To change the chart rotation speed (of the current range only), press and release the left button (#1) to select 24 Hour rotation and press and release the right button (#2) to select 7 Day rotation. The LED will flash the appropriate number of times to show the chart rotation speed that is selected. To permanently save the chart rotation speed that has been selected, press and release the "change chart" button (#3) and the recorder will resume normal operation.

DRAW A TEST PATTERN

To test the operation of the recorder's pen and chart motors, a special test mode has been implemented. To initiate this test mode, first unplug the unit from the main power supply and disconnect the battery (if the recorder has the optional battery back up feature). Next, press and hold the "change chart" button (#3) (refer to Figure 1) and re-connect the recorder to the main power supply. Once power to the recorder has been established, release the "change chart" button (#3). Note: the pen(s) will not be moving if this step is successfully completed.

The LED will begin flashing in sequence to show the current chart rotation speed that is configured for the recorder:

Flash 1 time - 24 HOUR
Flash 2 times - 7 DAY

Without pressing the left (#1) or right (#2) buttons, press and release the "change chart" button (#3). The LED will turn solid green (stop flashing) and the pen(s) will begin to move off of the chart. Once the pen(s) has moved off of the chart and returned to the outermost graduation of the chart, the LED will begin flashing continuously. Once the LED has started flashing, press and release the left button (#1) to begin the drawing of the test pattern.

 

ADJUST PEN SPAN

To adjust the span of the pen, first unplug the unit from the main power supply and disconnect the battery (if the recorder has the optional battery back up feature). Next, press and hold the "change chart" button (#3) (refer to Figure 1) and re-connect the recorder to the main power supply. Once power to the recorder has been established, release the "change chart" button (#3). Note: the pen(s) will not be moving if this step is successfully completed.


A1

R70-32 (WEB)
REV(12-04) D

<<Previous Page | Home | Next Page>>